Our powdercoated steel strut spacers are designed to work with your factory Honda suspension. Complete kit includes: set of 4 spacers (2 front & 2 rear), hardware and detailed illustrated installation instructions. These spacers do not require the disassembly of the strut. Our kits are powder coated for a durable, attractive finish and use zinc plated grade 10.9 hardware. For off road use only.
Please see our other listings for more lift kits and parts. All vehicles are different and lift height can vary due to the condition of the suspension before installing the kit. These numbers are averages from real world measurements before and after the kit, and should only be used as general guidelines. Q: Why are you claiming 2 inches of lift when the spacers are only 1.5 inches tall? The geometry of the suspension causes the actual amount of lift to be greater than the height of the spacers.
Q: How is the amount of lift measured? A: The amount of actual lift is measured from the fender lip to the ground. Q: Will I need an alignment after installing this kit? A: Yes, just as if you lowered your car, lifting changes the wheel alignment. It is also recommended to install camber correction kits for lifts greater than 1.
Q: Will lifting my car affect the axles? It depends on the amount of lift and the type of axles you have in your vehicle. Parts store rebuilt axles are more prone to having issues.In general, installing lift spacers GREATER than 1.5" on the front of your Honda will require a subframe drop or "body lift to maintain proper axle angle. Q: Do I need to replace my suspension bushings when installing a lift kit? A: It depends on the condition of your existing bushings. We always recommend inspecting your factory bushings and replacing them with urethane bushings such as Energy Suspension if needed. The added benefit of installing urethane bushings is that it allows the suspension to move more freely.
A: In most cases, yes. By lifting the suspension you are effectively raising the roll center of the car, which can cause additional body roll. Our lift kits are intended for off-road use where suspension travel and ground clearance are more important. The item "2 inch (51mm) Lift Kit for 1998-2002 Honda Accord by HRG Engineering" is in sale since Monday, January 21, 2019. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Lift Kits & Parts".
The seller is "hrgengineering" and is located in Mooresville, North Carolina. This item can be shipped to United States, Canada.